Silicone Round Ball 7/8" Mold

0 Review(s)

Your Price: $18.10

Part Number:3754

Quantity

Description
Customer Reviews

Create small soap balls with this silicone soap mold. Embed these cute soaps into a loaf or larger bar mold for a creative and unique soap design. These small soaps can also be used as single use bars for the gym!

Common Uses:
Melt & Pour Soap (MP). Cold Process Soap (CP). Cold Process Oven Process Soap (CPOP). Hot Process Soap (HP). Lotion Bars.

Points of Interest:
Maximum Temperature: 500ºF
Manufacturer: Crafter’s Choice®
Material: Silicone
Country of Origin: China

Country Of Origin: China

Helpful Product Information:

Style: Bar		Avg. Bar Weight: 0.2 oz
Bar Cavities: 27		Bar Depth: 0.8"
Bar Diameter: 0.8"		Bar Length: 0.8"
Bar Width: 0.8"		Max Temperature: 500ºF
Mold Capacity (oz): 5.4

International Nomenclature of Cosmetic Ingredients (INCI):
This product does need to be listed on the product ingredient label.

Common Name Ingredient Listing (FDA Approved):
This product does need to be listed on the product ingredient label.

Directions:
Melt & Pour Soap: Pour melted soap into silicone mold cavities. Allow soap to cool at room temperature until hard. Carefully remove soap from mold by gently pulling the sides away from the soap, and then push on the bottom of the mold until the soap starts to release. Grab hold of the soap and carefully pull out of the mold.

Cold Process Soap: Pour soap at trace into the mold cavities. After at least 24 hours, gently pull silicone mold to loosen its grip on the soap. Flip mold over onto a clean surface and gently push on the bottom of mold until the soap starts to release. Grab hold of the soap with a gloved hand, and allow soap to cure for 4-8 weeks. Note that some cp soap recipes may require a week to harden enough to remove from the mold. If this is the case with your recipe, we recommend adding sodium lactate to your recipe to assist with creating a harder bar faster.

Cold Process/Oven Process Soap: Pour soap at trace into the mold cavities. Preheat oven to 170ºF then place mold in oven. Turn oven off, and keep soap in oven overnight. The next day remove mold from oven. Carefully remove soap from mold by gently pulling the sides away from the soap, and then push on the bottom of the mold until the soap starts to release. Grab hold of the soap and carefully pull out of the mold. Allow soap to cure for 2 to 4 weeks.

Hot Process Soap: Scoop hot process soap into mold cavities. Gently tap the mold onto the counter to remove air pockets. Allow soap to cool and harden. (This can take up to 48 hours.) Carefully remove soap from mold by gently pulling the sides away from the soap, and then push on the bottom of the mold until the soap starts to release. Grab hold of the soap and carefully pull out of the mold.

Solid Lotion: Pour melted lotion mixture into mold cavities. Allow mixture to solidify. Carefully remove solid lotion from mold by gently pulling the sides away from the solid lotion, and then push on the bottom of the mold until the solid lotion starts to release. Grab hold of solid lotion and carefully pull out of mold.

Care:
Hand wash in warm sudsy water.